Piano parts

What is an agraffe?

An agraffe (uh-GRAF) is a small brass guide screwed into a piano’s iron plate, near the tuning pins. Each string of a note passes through a hole in it, and that hole marks exactly where the string’s speaking length begins.

What it does

A piano string runs from its tuning pin, over the plate, across the bridge on the soundboard and down to a hitch pin. Only the part between two fixed points vibrates and makes the note: the speaking length. At the tuning-pin end, the agraffe is one of those points. It does three jobs:

  • Ends the speaking length cleanly. The string bears against the edge of the hole, so the vibrating length starts at a fixed, hard point.
  • Spaces the strings. The holes set the gap between the two or three strings of a note, so the hammer strikes them all evenly.
  • Holds the string against the hammer. In a grand the hammer strikes upward; a string that only rested on a bearing edge could be lifted off it. Threaded through the agraffe, it’s held in both directions.

Where it sits

On a grand, lift the music desk and look just beyond the tuning pins: the row of brass studs the strings pass through are the agraffes. They usually run through the bass and middle sections; in the treble a cast bar in the plate, the capo d’astro (or capo tasto) bar, does the same job. On an upright the same point sits near the top, below the tuning pins. Many uprights use a pressure bar there instead of agraffes; some have agraffes in the bass and tenor.

Where it came from

The agraffe is usually credited to the Paris maker Sébastien Érard, in the early 1800s, as pianos took on heavier strings and harder hammer blows. The word is French: agrafe, a clasp.

Why tuners care

When you turn a tuning pin, the string has to slide through the agraffe for the change to reach its speaking length. Friction there can hold some tension back, and the note settles later: one reason technicians strike firm test blows and set the pin carefully (seehow to tune a piano). A worn or loose agraffe can also buzz or make a note sound false, and agraffes are often replaced when a piano is restrung.

Agraffe Piano Tuner

Agraffe Piano Tuner is a strobe tuning app for piano technicians and pianists, named for this part: the point where a string’s sound starts. Its icon is a unison of three strings passing through the agraffe’s eye, in verdigris, the green that brass weathers to. Seehow it works.

Questions

What is an agraffe on a piano?

A small brass fitting screwed into the piano’s iron plate, near the tuning pins. Each string of a note passes through a hole in it, and the agraffe marks where the string’s vibrating (speaking) length begins.

How do you pronounce agraffe?

uh-GRAF. The word comes from the French agrafe, a clasp or hook.

Does every piano have agraffes?

No. Most grands have them through the bass and middle, with a capo d’astro bar taking their place in the treble. Many uprights use a pressure bar instead, though some have agraffes too.

Why is the app called Agraffe?

Because the agraffe is where a string’s sound starts: the exact point its speaking length is measured from. The name is a promise of precision at that point, and it belongs to the craft rather than describing the app.